Pneumatic screwdriver FAQ

Taizhou fengleiyi machinery&electronic co.,ltd. is a professional manufacturer of pneumatic tools for design, development, production, sales and service. It is located in the middle of China Gold Coastline. Water, land and air transportation is convenient, network, communication and information is developed. Of the coastal business in Zhejiang coastal city - Taizhou here is an important birthplace of China's stock cooperative economy. The company was founded in 2010, the predecessor of Taizhou Yuyu Pneumatic Tools Co., Ltd. Existing staff of more than 300 people, more than 30 professional senior technical staff.

   At present, the main production of industrial-grade assembly of pneumatic tools, is committed to the production industry, cutting-edge products, including professional-level specifications of the gun wind approved, wind guns, especially oil-type, hydraulic pulse pneumatic tools is the industry's cutting-edge products. The company's products are mainly used for automobile, motorcycle, electric car, bicycle assembly and maintenance of motor engines, generators, agricultural machinery, air compressors, small machinery and other products for the assembly of the world's automotive, pipe, ship and other industrial manufacturing and automotive After-sales service market widely used, and exported to Europe and the United States and the Middle East and other countries.

   One, plug the trachea that is, or leak?

   1, oil seal off. 2, switch spring broken.

   Second, the pneumatic screwdriver start does not turn?

   1, the rotor stuck. 2, the brake time is loose. 3, striker wear. 4, the bushing is too short.

   Three, pneumatic screwdriver with jump?

   1, brake hexagonal shaft spring (time) too tight. 2, jump off the steel ball hole within the burr, grinding with a sharpening knife. 3, the brake spring to reduce the elasticity, the spring stretch or replace. 4, the internal parts of the clutch wear and tear, replace the parts. 5, air pressure is too low, increase the pressure. 6, thimble is too long, grinding a little.

   Fourth, the gun type pneumatic screwdriver positive and negative speed is not the same?

   1, exhaust is not smooth. 2, muffler part of the exhaust poor.

   Five, screwdriver positive and negative switch turn?

   1, the valve plate above the spring elastic compression. 2, the valve plate rust, with sandpaper grinding valve plate.

   Six, the screwdriver automatically jump off?

   1, the bushing is too long, grinding part. 2, hit the spring to reduce the spring, to stretch a little.

   Seven, screwdriver parts no problem, but not turn?

       The distance between the motor and the clutch is too tight and the gasket is added.

   Eight, pneumatic elbow part does not turn?

     Check the elbow inside the screws whether loose, with or without foreign body stuck, if any, then adjust the screw, clean up foreign matter.

   Nine, pneumatic screwdriver running even jump, but forced to stop the normal pressure, the reason?

   1, screwdriver head cap spring, hit the spring to reduce the spring, the spring stretch on the long point. 2, thimble is too short. 3, hit sets of wear and tear. 4, the clutch head wear. 5, steel ball hole burr.

   10, pneumatic screwdriver large torque brake brake does not move? Do not get off?

    1, wear sets of wear. 2, will be valve plate wear