Pneumatic tool maintenance and maintenance

Companies adhering to the "frank and dare, seeking fine broad, forge ahead" business philosophy. Will, as always, for the world to provide quality products and improve its services. We adhere to the "customer first" principle for the majority of customers to provide quality services, we also provide OEM and ODM services. According to customer requirements, design specifications, in the quality of the first requirements for the majority of customers to bring convenience.

   Safety standard

    (1) Before using the pneumatic tool, be sure to read this manual, only in full understanding of the content before you can use pneumatic tools in the workplace, and the need to strictly enforce its content.

   2. [warning]

    When using the tool, do not exceed the maximum operating pressure (100PSI / 7.0BAR / 7.0kg / cm2) often make pneumatic tools work in the environment beyond the operating pressure, will greatly reduce the life of the tool itself.

    (2) When replacing the tool or accessory, first remove the pneumatic tool from the air source.

    (3) Wear your goggles as much as possible.

    (4) Do not wear loose clothing during operation. Scarves. Tie or jewelry, so as not to be moving or rotating parts involved in the danger.

    (5) When the pneumatic tool is connected to the high pressure air supply, do not press the trigger when not in use.

    (6) at any time to ensure that the situation of spare parts, loose parts can cause serious danger.

    (7) When replacing wear parts, use special spare parts.

    (8) Do not use air pressure tube damaged or impact.

    (9) Do not point the tool to yourself or others.

    (10) before use, check the air pressure pipe is more fragile or damaged, if found the above situation, please immediately update to maintain safety.

    (11) Lock all nuts, screws, and make sure that all equipment is in a safe state.

    Moderate lubrication is the responsibility of the tool user. Compressed air will be water vapor condensation, easy to cause corrosion If there is no moderate lubrication will greatly shorten the life of pneumatic tools.

   [Note]

    Pneumatic tools are lubricated before and after use.

    Air motor part of the lubrication -

    The air motor needs to be lubricated daily, but not too many times.

   4. Precautions

    (1) Do not disassemble the parts to be repaired or replaced.

    (2) Please be careful to avoid damage to the tool or parts when disassembling.

    (3) when the removal of impurities can not enter.