Pneumatic screwdriver safety instructions

Feng Lei Yi Electrical and Mechanical Company adhering to the "frank and dare, seeking fine broad, forge ahead" business philosophy. Will, as always, for the world to provide quality products and improve its services. We adhere to the "customer first" principle for the majority of customers to provide quality services, we also provide OEM and ODM services. According to customer requirements, design specifications, in the quality of the first requirements for the majority of customers to bring convenience.

    Feng Lei Yi Electrical Co., Ltd. all the staff to the new market philosophy and excellent quality to meet the new era of the market opportunities and challenges, Ye-welcome home and abroad to discuss the order.

   1, smooth conversion valve indicator switch (R forward-L reverse) to the direction of rotation.

   2, the pressure can start the motor rotation, can save the lift carry the action, increase efficiency.

   3, the torque is large (tight) small (loose) easy adjustment, torque adjustment ring to tighten the right, torque increases larger, adjust the ring to the left tight, torque reduction smaller

   4, when the load reaches the pre-set torque value, the air motor will automatically stop.

   5, gently press the screwdriver shaft cap can quickly replace the screwdriver head, relax and extinguish the upper seat can replace the torque jacket (optional).

   Air supply conditions and precautions:

   1, when the air compressor to accommodate too much water and dust, for the aerodynamic tools have the most adverse impact, so the pressure pipe must be equipped with water vapor filters and automatic supply of lubricants, to filter the undesirable substances, and each Day to drain the water from the drain.

   2. When installing the new pneumatic screwdriver, connect the intake line (orange - option) to the intake nut (black).

   3, to prevent the pressure of the pipeline and pipe and then gather water and dust, to keep the pipeline clean, or long-term use of the pipe diameter may become smaller.

   4, when the pneumatic screwdriver and the pressure pipe from the time, can not make the pressure pipe joints fall on the floor, this will accumulate dust or unwelcome material into the air pressure pipeline.

   5, the general pressure of the main air pressure pipeline 7.0kg / cm2 or 8.0kg / cm2, in conjunction with the pneumatic screwdriver before the auxiliary pressure pipeline must be installed before the regulator pressure stabilized at 5.5kg / cm or 6kg / cm, The inner diameter of the pipe is selected as the recommended diameter of the tube, which is very important and necessary for the aerodynamic screwdriver to obtain the maximum torque value. However, it is recommended that the air pressure of 5.0 kg / cm2 is sufficient for most of the screw operation The Can not be used to make the specified pressure, otherwise the life of the pneumatic screwdriver will be shortened.

   6, the device regulator can stabilize the pressure line pressure to ensure that the pneumatic screwdriver torque accuracy (repeat accuracy).

   Maintenance matters:

   1, long-term use of pneumatic screwdriver must be lubricated before the oil, or pneumatic screwdriver will be damaged. Ready to work before the lubrication to save.

   2, the use of manual tanker lubrication before the first pneumatic screwdriver and pressure pipe from the oil, then the oil (# 30- # 60) into the intake nut, connected to the pneumatic screwdriver and pressure tube, the pressure screwdriver idling about two Seconds to complete the lubrication to save. 1-2 times a day to extend tool life.

   3, replace the jacket when the first jacket into the torsion adjustment ring, and then use the air pressure blowing, so that the jacket diameter larger, while squeezing into the jacket can be.