Pneumatic tool maintenance

Feng Lei Yi Electrical Co., Ltd. all the staff to the new market philosophy and excellent quality to meet the new era of the market opportunities and challenges, Ye-welcome home and abroad to discuss the order.

   1. To avoid unnecessary load-free operation Pneumatic tools no load operation, is the tool parts early loss and heat, so that the reasons for the reduction of operating efficiency, be sure to pay attention. In particular, the impactless type of shock-type gas trigger operation, is the impact of parts damage and reduce the impact of the reasons for the impact.

   2. Do not forget to fill the oil every day As the pneumatic part of the pneumatic tool often high-speed operation, the use of the lack of oil will make parts of the rapid wear and tear, resulting in abnormal operation and other phenomena, the useful impact on the useful life of the tool. Therefore, please put a small amount of lubricating oil (20 # oil) into the pneumatic tool at the beginning, then run at low speed. In this way, the lubricating oil is automatically sprayed inside the motor, the motor is running smoothly, and the service life is naturally prolonged. This oil 2 to 3 times a day, from the oil plug or inlet into the injection. In addition, the clutch, reducer and impactor and other operating parts, please 1 to 2 times a month, coated with a small amount of lithium grease; bearings and other parts, according to the frequency of use of the corresponding regular inspection (3 months 1 ), Add lithium-based grease.

   3. prohibit casually throw or free to beat the pneumatic tool shell made of aluminum alloy material, the gap between the internal parts is very small, please love to use, to prohibit random throw or random beat.

   4. Please understand the body structure, the performance of the implementation of repair, decomposition and maintenance, moderate oiling and prevent dust intrusion, is the use of attention should be matters. In addition, must also be carried out bearing or gear part of the grease exchange and leaf inspection and other regular decomposition and maintenance. Regular maintenance can not only keep the tool in good condition, but also significantly extend the life of the tool